Introduction

Extraperitoneal laparoscopic sutures usually require iterative knots that are successively advanced into the abdominopelvic cavity with a knot pusher. Because this procedure can be tedious, we describe a simplified technique inspired by the Roeder’s knot that may be applicable to any laparoscopic procedure requiring separate knots.

Interventions

This technique of extraperitoneal laparoscopic suture is highlighted through two surgical procedures: a mesh fixation during a sacrocolpopexy and an ovariopexy after interadnexal hysterectomy.

Sacrocolpopexy (mesh fixation) for a pelvic organ prolapse in a 61-year old patient (Figures 1, 2, 3): After the intervesical vaginal dissection is accomplished, a precut polypropylene mesh is secured to the anterior wall of the vagina and the uterine isthmus, using a braided non-absorbable polyester 2-0 suture of 90 cm of length with a half-circle needle of 26 mm (Ethibond^®, Ethicon, Somerville, NJ, USA). Once this step is performed, the needle-holder introduced through the suprapubic operator port grasps the wire about 2 cm from its point of insertion on the needle and exits it. Thus, the needle is brought outside. A self-locking sliding knot is then made. To do this, a simple half-hitch knot is performed first. The end of the free strand (without the needle) makes three rounds around both suture limbs. A second half-knot is performed around one side of the suture limbs before the end of the free strand enters in the loop of the first half-hitch knot. By formalizing this knot, we obtain 1:3:1+1 (1 half-hitch, 3 winds and 2 locking half-hitches). This creates a sliding knot that will be lowered by simply pulling on the axial strand. The free strand is then cut to about one centimeter of the knot. Gentle but sustained traction allows the advancement of the knot, which is slid down the trocar into the abdominal cavity and comes to block itself once arrived at the destination under permanent laparoscopic control. Once the knot is seated, the needle holder can maintain pressure on the knot to strengthen its tightening and lock it. The suture is then cut to a centimeter.

Ovariopexy in a 43-year-old woman after hysterectomy without adnexectomy (fibromatous uterus): The surgical procedure consists in the joigning of the round and utero-ovarian  ligaments’ stumps through a similar technique (Figures 4, 5, 6, 7, 8).

Discussion

This technique avoids the need for repetitive use of the knot-pusher in performing extraperitoneal knots. Time saved in the operating room and limited gestures can theoretically contribute to decrease cost and improve safety. Although our intimate conviction goes in this direction, further studies are needed to better evaluate this procedure.

Knot safety depends mainly on the number of initial turns around the standing part and on the additional half-hitches to secure the knot afterwards (1,2). Three round turns seem sufficient if the ligature is braided, but 4 turns are needed to secure the knot if the suture material is slippery monofilament material. This method, which can thus contribute to improve safety as well as surgical ergonomics, is fully illustrated in the present work (graphical abstract and video). We also use this technique to perform an ovariopexy (accomplished after a laparoscopic inter-adnexal hysterectomy for benign pathology), which consists of the joining of the round and utero-ovarian ligaments’ stumps. This ovariopexy is justified by the risk of ovarian torsion which can occur, probably due to the rare occurrence of adhesions and the fee long infundibulopelvic ligament that remains (3).

In order to secure this surgical procedure and reduce the risks of failure, prior practice on simulator seems necessary before its implementation.

Rehabilitating a process historically used during laparotomic procedures, this technique avoids iterative intra-abdominal gestures and expedite the knot-tying steps.

Ethics: Study ethics approval was obtained on 30 June 2017 (CECIC Rhône-Alpes-Auvergne, Grenoble, IRB 5923).

Conflict of Interest: No conflict of interest was declared by the authors.

Financial Disclosure: The authors declared that this study has received no financial support.